Lead Acid/Lithium battery charger make by XH-M603 charge controller (computer power supply charger)



Lead Acid battery charger make using XH-M603 charge controller (computer power supply charger)

Parts Required:

1) 150W DC-DC 10-32V to 12-35V 6A Step-Up Converter –
2) 600V 15A 6P Wire Terminal Connector –
3) DC 12-24V XH-M603 Lithium Battery Charge Control Protection Board –

DIY- Computer Power Supply Bench PSU –

Thank you.
Subscribe for more future creative project videos.
Subscribe LahisTech:

Tunes by:

Tune1
Song: Fredji – Welcome Sunshine (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link:
Tune2
Song: Nekzlo – Found You (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link:
Tune3
Song: Sappheiros – Lights (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link:
Tune4
Song: MBB – Fresh (Vlog No Copyright Music)
Music provided by Vlog No Copyright Music.
Video Link:
Tune5
Song: Wonki – Somewhere (Vlog No Copyright Music)
Music provided by Vlog No Copyright Music.
Video Link:

source: https://noviway.com

Xem thêm các bài viết về Công Nghệ: https://noviway.com/category/cong-nghe/

6 thoughts on “Lead Acid/Lithium battery charger make by XH-M603 charge controller (computer power supply charger)

  1. So why do you use the voltage converter? Just because youre source doe snot go higher than 12 volts? I mean I planned to connect the XH-m603 to a solar panel . It's voltage can be up to 30 volt. (seen max 29 so far) thats why I got this little gadget. Assuming it can handle variable voltage inputs.

  2. Thanks for this video ,It projects are really very helpful keep it up good work👌👌👌💐💐💐💐💐💐
    One Questions- Which smartphone or Camera U are Using to shoot this videos,
    Thanksssssssz

Leave a Reply

Your email address will not be published. Required fields are marked *